www.customduo.co.uk

CustomDUO

www.customduo.co.uk

Omni v5

gallery/blackrat_v5_l (1)

The Omni v5 is the most advanced of our LED conversion modules available for the Petzl Duo, with user programmable power settings up to 620 lumens. 

 

Now available with new Cree XP-G3 s5 LEDs providing minimum of 172 lumen/watt @85degC and 187 lumen/watt @25degC. Light temperature 5000K (neutral white).

 

.... and also 3000k WARM Cree XP-G3 s3 LEDs providing minimum of 156 lumen/watt. 

 

 

 

 

£70

 

Specification

 

  • Twin high power s5 XP-G3 LEDs (172 lumen @ 350mA @ 85 degC) 5000k neutral tint, as standard
  • Smooth spot optic for distant focus & flood LED (with efficient optic for forward bias), for maximum usability
  • LEDs operated separately or blended together
  • Programmable; range of power combinations to best suits your individual requirements
  • 620 lumen maximum output; combined 'spot' 310 lumen and 'flood' 310 lumen
  • Battery charge level indicator. Red SMD LED will blink 1-5 times to indicate charge. Visible on hand held in front of lamp 
  • Super robust circuit architecture. Custom heat sink, and discreet thermal management
  • Very simple fitting; push fit directly into existing Duo pilot bulb connections
  • Will work with any Petzl Duo
  • No power drain when lamp is switched 'off' with batteries connected
  • 6.0 volt maximum input
  • Progressive dimming at end of battery charge; lamp will not just shut off when batteries are flat

 

Operation Overview  

 

To switch between the four factory default power settings (see following table), in a looping sequence, use the down switch on the Petzl Duo. Switch on-off-on-off to sequence between settings 1-2-3-4 ... 1-2 etc. 

'Double switch' to operate moon mode (10mA flood), i.e. (swift double operation of switch, i.e. on-off-on). The red indicator LED will blink 1 to 5 times to indicate battery charge level. Lamp will run in moon mode until next switched off.

 

 

 

 

 

 

 

 

 

 

 

 

For information about fitting, operaton, and how to program and configure settings, see the Omni v5 Operation page. 

 

Factory Setting

Spot LED

Flood LED

Output

(estimated)

Duration

(est.  using 2500mAh
eneloops)

1 (fixed)

-

150mA

73 lumens

16 hours

2 (programmable)

-

350mA

172 lumens

7 hours

3 (programmable)

150mA

350mA

245 lumens

5 hours

4 (programmable)

700mA

-

310 lumens

3.5 hours

'Double-switch'

-

10mA

5 lumens

includes battery
level indicator

gallery/cree led 5000k
gallery/cree led 3000k